Bell Taps Logo Chamfered Recesses

In the process of casting a hole by a core form or punching a hole with a punch die a sharp burr edge can form on the surface. We cut this burr off with countersink bit so the hole has a rounded edge that will not scratch the dance floor. To chamfer the holes means another step in the processing of the castings, but to us it is very important. Remember, you are a guest when dancing on someone else's floor. Care should be exercised to prevent damage.

      Check out our:
  • Wind Chimes
  • Belt Buckles
  • Silencers
  • Logo Pins
  • Caps
For information or orders contact
Bell Taps Mfg.
568 Old North Shore Road
Two Harbors MN 55616